![]() When installing horizontal siding, always start from the bottom and work your way to the top. One edge Siding Installation Installing One-edge Siding RBM Lumber’s Log Cabin Siding is acclimated and ready for installation. This finishing is in addition to the application of house wrap. This will prevent the absorption of moisture from the back side of the log siding. If your siding is subject to intense sunlight with little or no shade, we suggest the application of two coats of stain and of a coat of finish on the back of the boards. Because siding shrinks and expands with fluctuating seasonal humidity, a white line can be left at the point of shrinkage. If staining is done after installation, it should be done during the driest part of the year and after it has had at least 2 weeks to dry. Siding should be stained on the front and back before it is installed. Decking screws are recommended for installations that are south-facing or any area where the siding will be exposed to intense sunlight with little or no shade. Black siding nails, galvanized nails, steel siding nails, and 3” decking screws can all be used. Nail the siding 2/3 to 3/4 of the way down the board, one nail on each stud with sixteen pennie (16d) siding nails or larger. Do not use more than one nail on one board through a stud, as this may cause splitting. In general, 2×4, 2×6, and 2×8 trim boards should be installed prior to the log siding. Start installing log cabin siding from the bottom and work your way to the top, using a level and/or string line. If you have any questions about your particular application, please ask us. is not responsible for shrinkage of lumber, splitting, or other issues caused by improper installation. RBM Lumber’s Siding material is acclimated and ready for installation. If staining is done after installation, it should be done during the driest part of the year and after it has had at least 2 weeks to dry. Over-nailing can cause splitting of the board on the back side. Pound in the nail only until it is snug against the board. ![]() Because one-edge siding is a true random width you have to sort the entire batch into like sizes and run each course individually. For our 8″ bevel we recommend 6 1/2″ exposure, for 6″ bevel 5″ exposure and for 4″ bevel 3 1/2″ exposure. This allows for any variation in the width of the boards. On bevel siding do not measure down from the top edge to set the next course but rather measure the exposure you want from the bottom of the last course. It is absolutely crucial that you hit the stud with the fastener to have the best chance of holding. This allows the boards to shrink and expand as the seasons change without splitting the board. Important note: virtually all real wood siding will try to cup when it is exposed to the sun and weather so it is better to use larger nails or screws during the original installetion to prevent it from pulling off the wall.Īny type of lap siding bevel, drop siding, channel rustic, live edge, etcĪlways nail just above the top edge of the board underneath so you don’t nail through both pieces. The size and fasteners will depend on the type of siding and wood species. In general, all trim boards and corner boards should be installed prior to the siding. Every few courses measure from the last course to the top of the wall in several places to be sure you are going up evenly. It is critical that the bottom board is level before continuing the installation. Always start from the bottom and work your way up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |